Standard Complete Operation Process of Industrial Vacuum Freeze Dryers

Jul 31, 2026 Leave a message

Full Text

Step 1 Pre-production Inspection & Preparation

Check power supply, refrigeration unit, vacuum pump system, hydraulic pipeline and sealing door to ensure no leakage, abnormal noise or fault alarm.

Clean the inner cavity and material trays thoroughly to remove residual materials and avoid cross-contamination of different freeze-dried products.

Pretreat raw materials: Cut fruits, vegetables and meat into uniform sizes, control material thickness within 10-20mm, spread evenly on trays to prevent overlapping; yogurt and liquid raw materials shall be poured evenly to ensure consistent sublimation efficiency.

Step 2 Equipment Pre-cooling

Switch on the main power, start the refrigeration system, set cold trap temperature according to material characteristics (range: -45℃ ~ -75℃).

Wait 30-60 minutes until cold trap temperature stabilizes at the preset value.

Step 3 Material Loading & Program Setting

Push the full material trays into the drying chamber, close and lock the sealed door tightly.

Operate the touch screen PLC system, select the matched preset freeze-drying curve for target products (freeze-dried strawberry, okra, chicken cubes, yogurt cubes etc.). Parameters include pre-freezing time, shelf heating temperature, target vacuum degree and total drying duration; manual adjustment is available for customized raw materials.

Step 4 Vacuum Sublimation Drying Stage

Start vacuum pump group, the internal vacuum degree gradually drops to 10~30Pa, the system automatically enters primary sublimation drying. Ice inside materials converts into water vapor and is captured by cold trap.

After primary drying completes, the machine automatically enters secondary desorption drying to remove bound water inside materials, further lower residual moisture of finished freeze-dried goods.

Real-time monitor temperature, vacuum and material status via touch screen throughout the whole process, the system automatically records all production data for traceability.

Step 5 End of Drying & Discharging

When the system judges the drying standard is reached, the program automatically stops heating and vacuum system.

Slowly inflate dry air into the chamber to balance internal and external air pressure, then open the sealed door.

Take out material trays quickly, pack freeze-dried finished products immediately to prevent moisture absorption.

Step 6 Post-operation Cleaning & Shutdown

Clean inner cavity, trays and cold trap thoroughly after discharging, remove ice frost from cold trap.

Close vacuum pump, refrigeration system and main power supply in sequence.

Record production parameters and equipment operation status for daily maintenance file.

Key Operation Notes

Different universal freeze-dried products need corresponding exclusive process curves, do not mix and match parameters randomly.

Strictly control material thickness; too thick raw materials will cause incomplete drying and unqualified moisture content.

Keep the sealing strip intact to avoid vacuum leakage which affects finished product quality.